The structure of pneumatic diaphragm valves is characterized by a set of thin hemispherical metal diaphragms clamped into the valve body as a barrier between the valve stem and the fluid. Valve closure is achieved by pressing the valve disc against the valve seat by the stem head and metal diaphragm. The valve is opened by means of an internal spring, and the valve disc rises when the stem rises and comes into contact with the diaphragm. Since the stroke of the valve is equal to the stroke of the membrane, the characteristic lift of this valve is much smaller than that of ordinary valves.
In order to overcome the resistance loss caused by low lift, the valve seat and flow area are larger than those of ordinary valves, in order to obtain a larger flow rate. Due to the larger seat of this valve, its force is much greater than that of the usual valve in order to obtain sufficient sealing force on the valve disc, because there is no direct contact between the valve stem and the valve disc. The valve disc does not pass through the stem and leave the seat, so the valve is suitable for unidirectional flow with differential pressure, and the medium usually comes from "under the seat". However, a large amount of backflow should be avoided in use to avoid affecting the closure of the valve. Generally speaking, it is economical and effective to choose a metal diaphragm valve at high temperature and high pressure, and the valve can also be selected in low temperature and low pressure occasions where synthetic rubber diaphragm valves are not desired.

The diaphragm separates the lower valve chamber from the upper bonnet cavity, so that the valve stem, disc and other parts located above the diaphragm are not corroded by the medium, eliminating the packing sealing structure, and there will be no medium leakage.
1. The diaphragm made of soft seals such as rubber or plastic has good sealing. Since the diaphragm is a wearing part, it should be replaced regularly according to the characteristics of the medium.
2. Limited by diaphragm material, diaphragm valve is suitable for occasions with low pressure and relatively low temperature.
3. Diaphragm valves can be divided into six types: roof type, direct flow type, globe type, straight-through type, gate type and right angle type according to the structural form; The connection form is usually flange connection; According to the driving mode, it can be divided into manual, electric and pneumatic, of which pneumatic drive is divided into normally open, normally closed and reciprocating three.
4. Generally, it is not suitable for pipelines with temperatures higher than 60 degrees and conveying organic solvents and strong oxidation media, nor should pneumatic diaphragm valves be used in pipelines with higher pressure.





