The main advantages of electric actuators are high stability and constant thrust that users can apply. The thrust generated by the largest actuator can be as high as 225000kgf. Only hydraulic actuators can achieve such a large thrust, but the cost of hydraulic actuators is higher than that of electric actuators. Much higher. The anti-deviation ability of electric actuators is very good, and the output thrust or torque is basically constant. It can well overcome the unbalanced force of the medium and achieve accurate control of process parameters, so the control accuracy is higher than that of pneumatic actuators. high. If equipped with a servo amplifier, the forward and reverse effects can be easily interchanged, and the off-signal valve position state can be easily set. When a fault occurs, it must stay in the original position, which is something that pneumatic actuators cannot do. The device must maintain its position with the help of a combined protection system.
The main disadvantage of the electric actuator is that its structure is more complex and it is more prone to failure. Due to its complexity, the technical requirements for on-site maintenance personnel are relatively high; the motor generates heat when running. If it is adjusted too frequently, it is easy to cause the motor to malfunction. Overheating will cause thermal protection and will also increase the wear of the reduction gear; in addition, it runs slowly. It takes a long time from the regulator outputting a signal to the regulating valve responding and moving to the corresponding position. This is It is inferior to pneumatic and hydraulic actuators.
For relevant principles, installation and use of electric valves and valve quotations, please pay attention to Zhejiang Heyue Flowtech Co., Ltd.






